How To Remove Lower Dash Panel Chevy Silverado

How to Remove a Silverado Nuance

past Chris Moore

Dashboard of automotive image by TekinT from Fotolia.com

The dashboard on the Chevy Silverado truck is made up of several trim panels connected to one big upper trim pad. Each smaller panel tin can exist removed individually, though you must remove some of them before you lot can remove others. You'll demand to remove other components besides to detach the chief trim pad. The exact types of trim panels and the style to remove them tin can vary depending on the year of the Silverado.

Preparation

Pace one

Turn the wheels so they face forrard and block them, then apply the parking brake and lower the shift lever as far as information technology will go.

Stride ii

Tilt the steering wheel down as far as it volition go if the truck has a tilt steering column.

Footstep 3

Disconnect the negative battery cablevision.

Pace 4

Remove the cover concealing the fuse and relay box, which is located at the left end of the dash at the knee bolster.

Remove the airbag fuse from inside the relay box and wait at least two minutes for the airbag power supply to be deleted.

Trim Panels

Pace 1

Grab hold of the musical instrument cluster bezel and gently pull it out to disconnect information technology from the retaining clips and remove it from the dash panel.

Stride ii

Remove the knee bolster's screws with a screwdriver--the instrument bezel must be removed--and pull the eternalize away. Disconnect the airbag electric connector from the steering column.

Pace iii

Detach the centre and right side air outlets by pushing the outlet's swivel part as far to the left as you can, pushing the rest of the outlet to the left and pulling the outlet out of the dash.

Step 4

Open the glove box, squeeze the compartment's sides together and pull the door downward so the bumpers clear the stops. Remove the screws at the door'due south bottom hinge to remove the glove box.

Disconnect the lower sound panel by removing its screws. These are usually located at the right side of the musical instrument panel.

Upper Trim Pad

Stride ane

Remove the stereo past squeezing its mounting clips or removing its mounting bolts with a wrench (this depends on the year), pulling it out and disconnecting the antenna lead and electrical connector.

Step 2

Remove the heater/AC control assembly past releasing its retaining tabs, pulling the unit of measurement from the dash and disconnecting its electric connectors and control cables. Remove the instrument cluster by disconnecting its screws and electrical connectors.

Pace 3

Disassemble and remove the center console--remove the screws in the bottom of the panel floor, in the loving cup holder insert, and at the trim console betwixt the console and instrument panel. These screws may require a hex wrench.

Step four

Unscrew and remove the lower dash trim panel, which is the panel the glove box was continued to.

Step five

Insert a pry tool into the holes where the air ducts were and push out the ends of the dashboard take hold of bar to remove the bar.

Pace half dozen

Pry off the windshield's post interior trim strips with a trim tool.

Remove the retaining screws for the upper instrument console trim pad--they are usually at each end of the panel and in the duct openings-- lift off the trim pad and disconnect all electric connectors.

References

• "Chilton General Full Size Trucks Repair Manual;" Jeff Kibler; 2006

Things You'll Demand

• Screwdriver
• Wrench
• Trim stick
• Pry tool
• Wheel blocks

Writer Bio

Chris Moore has been contributing to eHow since 2007 and is a member of the DFW Writers' Workshop. He received a Available of Arts in journalism from the University of Texas-Arlington.

More Articles

Source: https://itstillruns.com/remove-silverado-dash-6110465.html

Posted by: rodriguescaptungthe.blogspot.com

Share this post